Sample Collection Instructions
Here’s a simple, step-by-step overview of the collection process for both the Gut Map or GLP-1 Map kit to ensure your samples are processed accurately.
Microbiome sample collection (Gut Map & GLP-1 Map)
Prepare: When you are ready, place the provided toilet seat cover over the toilet. (For babies, you can collect the sample directly from a clean diaper).
Collect: After your sample is deposited on the cover, put on your safety gloves and open the collection tube. Use the scoop attached to the lid to collect the sample.
Fill: Transfer the sample into the tube until it reaches the fill line.
Clean & Seal: Flush the cover down the toilet. Use the provided wipes to clean the outside of the tube, then close the lid tightly.
Storage: Place the tube back into the biohazard bag and put it in the freezer immediately.
Log: Open the Dayhoff app and log the exact date and time of your collection.
You will repeat this process for a total of three samples. To get the most accurate insights into your microbiome, collect these one at a time throughout the span of one week.
Blood sample collection (GLP-1 Map)
Before beginning, be sure to wear short sleeves and have your phone or another device ready to use as a timer.
For the most accurate results, test in the morning after fasting for 6–8 hours.
Make sure you have the following supplies:
Tasso collection device
Alcohol wipe
Bandage
Foil pouch
Return bag and box
Collecting your blood sample
Warm your arm and prep the area: Rub your upper arm for approximately 30 seconds, or until it feels warm. Use the alcohol wipe to clean the collection area on your upper arm.
Prepare and apply the device: Open the pouch and remove the Tasso device. Remove the button cover and the paper backing from the adhesive. Place the device firmly on your upper arm with the sample pod pointing downward.
Begin collection: Press the button quickly and firmly until it cannot go any farther. Hold it for two seconds, then release.
Collection: Start your 5 minute timer. Blood may take up to one minute to appear. The indicator dots will begin filling from the top.
If you don't see any changes after one minute, you may need to press or tap the button again with more pressure to ensure it is fully activated.
Remove the device: If all four dots fill and you can see blood at the bottom of the sample pod, stop the timer and gently peel the device from your arm. Otherwise, remove the device after five or six minutes. Ideally most, if not all, dots are filled before removal.
Apply the bandage: Place the provided bandage over the collection area.
Package the sample: Remove the clear film from the sample pod. Place the entire device inside the foil pouch, then place the pouch inside the return box.
Label and seal: Write the current date and time on the flap, then seal the package.
Return the sample: Ship or return the blood sample on the same day it is collected, following the return instructions provided with your kit.